Skip to content
Call or text (608) 927-6750
A corroded section of copper pipe cut out and laid on a towel next to a new copper repair section, with the new pipe run visible along the joists and a work light

Burst Pipe Repair in Beloit, WI

Updated

Get a free quote

A licensed plumber replies with a price. Nothing is booked until you say yes.

Rather talk? Call (608) 927-6750 or text us.

Short answer

Ready for a price on burst pipe repair?

Call, text, or send the form. You get a price back before any work is scheduled.

A burst pipe is the one plumbing call where minutes matter more than price. Close the main shut-off, open a faucet on the lowest floor to drain the lines, and turn off the water heater if the leak is near it. Then a licensed plumber cuts out the damaged section and replaces it. If the pipe froze first, the frozen pipe repair page covers the thaw.

What a burst pipe repair costs

JobTypical costSource
Burst pipe repair$1,000 to $4,000Angi
Leaking pipe repair, small$150 to $350HomeAdvisor
Per linear foot of pipe$150 to $250HomeGuide
After-hours rate1.5 to 3 times normalAngi

The plumbing is usually the smaller bill. Opening and patching walls and ceilings and drying the area are separate trades. All plumbing prices are on the plumber cost page.

Who owns which part of the water line in Beloit

The City owns the service from the main to the curb stop; the homeowner owns the part from the curb stop to the house (City of Beloit). A break on the street side of the curb stop is the City's to fix. A break between the curb stop and the house, or anywhere inside, is yours. If the house valve will not close, the City can shut the curb valve. Its 2026 fee schedule lists a curb valve turn-on at $30 from 7 a.m. to 4 p.m. and $50 at other hours (fee schedule).

The first ten minutes

  1. Close the main shut-off, usually on the line next to the water meter in the basement.
  2. Open the lowest faucet in the house to drain pressure out of the pipes.
  3. Turn the water heater to vacation or off, and shut the gas or breaker if water reaches it.
  4. Keep away from wet outlets and electrical panels.
  5. Photograph the damage before cleanup for your insurer.

The emergency shut-off guide shows where valves usually sit in Beloit basements and what to do if one will not turn.

Why pipes burst in older Beloit homes

Freezing is the usual cause, and Beloit sees 13.3 days a year at or below 0°F on average (NOAA). Age is the other. 28% of the city's homes were built from 1940 to 1959 (ACS 2020-2024), the years galvanized steel supply pipe was common, and the PSC's 2025 numbers list 1,966 galvanized customer-side service lines in Beloit (PSC). Galvanized pipe rusts from the inside and fails at the threads. When one section bursts, ask whether the rest of the run is worth replacing; see repiping and the galvanized pipe guide.

Can you fix it yourself

Wisconsin exempts minor repairs to faucets, valves, pipes and appliances from the license requirement, and an owner-occupant may do plumbing in their own single-family home (Wis. Stat. 145.06(4)). A push-fit coupling can stop a small split until a plumber arrives. A break in a wall, ceiling or the service line is a job for a licensed plumber, one of the most common emergency calls on the list of Beloit plumbing services.

Where this is done

Burst Pipe Repair across Beloit and the nearby Wisconsin and Illinois towns. Each town page has its own water, sewer and permit rules; the full list is on the service area page.

Common questions

Burst Pipe Repair: questions

How much does it cost to fix a burst pipe?

The plumbing repair typically runs $1,000 to $4,000 in national 2026 guides, before drywall and water cleanup, and 1.5 to 3 times the normal rate after hours. See the cost page.

What should I do first when a pipe bursts?

Close the main shut-off, open the lowest faucet to drain the lines, turn off the water heater, stay clear of wet electrical, and photograph the damage. Then call a plumber.

Who fixes a broken water line at the curb in Beloit?

The City owns the service from the main to the curb stop, and the homeowner owns it from the curb stop to the house. A break on the street side is the City's to fix.

What does Beloit charge to shut off or turn on water at the curb?

The 2026 fee schedule lists a curb valve turn-on at $30 from 7 a.m. to 4 p.m. and $50 at other hours.

Can I repair a burst pipe myself in Wisconsin?

Wisconsin exempts minor repairs to pipes and valves from the license requirement, and owner-occupants may work on their own single-family home. A push-fit coupling can hold until a plumber arrives.

Should I replace all my old galvanized pipes after a burst?

If one galvanized section failed from corrosion, the rest of the run is the same age. A plumber can show you the inside of the removed piece. See repiping.

Burst Pipe Repair: get a written price

Describe the problem and the town. A licensed plumber replies with a price, and no work starts until you agree to it.

Prices and the full service list are on the homepage for a plumber in Beloit.